Section 7: Replacement Procedures
SATO M10e Service Manual PN: 9001113A Page 7-12
Figure 7-9, Panel Board Replacement
POWER SUPPLY REPLACEMENT
1 Switch off the printer and disconnect the power supply cord.
2 Remove the top, front, left, right, and rear housing covers.
3 Remove seven screws (1, Figure 7-10) securing printer frame (2) to printer base (3).
4 Lift printer frame (2) away from printer base (3) exposing power supply (4).
5 Disconnect all wiring harnesses and cables from power supply (4).
6 Remove seven screws (5) securing power supply (4) to printer base (3).
7 Lift away defective power supply (4) and install replacement power supply (4) in its place.
NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance
on housing cover installation.
NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance
on housing cover removal.
NOTE: Ensure the print head assembly is latched closed prior to printer
frmae removal.
1
2
A
3
4
A
B
C
B
C
