Section 5: Printer Configuration
SATO M10e Service Manual PN 9001113A Page 5-15
MEMORY->CARDCOPY
COPYING
3. Press the ENTER key to select the option. If Yes was selected the copy
process will begin.
MEMORY->CARDCOPY
COMPLETED
4. Once the copy process is complete, press the ENTER key to step the
display.
CARD COPY/FORMAT
XXXXXXX ERROR
5. If an error is encountered in the copy process, one of the following
messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory available.
CARD->MEMORYCOPY
PROGRAM Y/N
This selection allows the printer firmware to be copied from the PCMCIA
Memory Card to the printer.
1. Use the CURSOR keys to step the cursor to desired option. If Yes is
selected, the printer will enter the Card Copy mode. If No is selected, the
display will advance to the mode display.
COPY START
YES NO
2. Confirm the selection by stepping the cursor to the Yes option. If No is
selected, the display will return to the previous selection.
CARD->MEMORY
COPY COPYING
3. Press the ENTER key to select the option. If Yes was selected the copy
process will begin.
CARD->MEMORYCOPY
COMPLETED
4. Press the ENTER key to advance to the next display when the copy
process is complete.
CARD COPY/FORMAT
XXXXXXX ERROR
5. If an error is encountered in the copy process, one of the following
messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory available.
MEMORY->CARDCOPY
PROGRAM Y/N
This selection allows the current firmware installed in the printer to be copied
to a PCMCIA Memory Card.
1. Use the CURSOR keys to step the cursor to desired option. If Yes is
selected, the printer will enter the Card Copy mode. If No is selected, the
display will advance to the mode display.
COPY START
YES NO
2. Press the ENTER key to select the option. If Yes is selected the copy
process will begin. If No is selected, the display will return to the previous
selection.
MEMORY->CARDCOPY
COMPLETED
3. Press the ENTER key to advance to the next display when the copy
process is complete.
CARD COPY/FORMAT
XXXXXXX ERROR
4. If an error is encountered in the copy process, one of the following
messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory available.
LCD DISPLAY DEFINITION
