Filter
Top Products
Section 3. Configuration
SATO M10e PN 9001101 Rev. A Page 3-25
COUNTERS MODE
The Counters Mode is provided to allow the user to access the internal printer cousters.
TEST PRINT MODE
The Test Print Mode offers 4 different status labels for troubleshooting. If DSW3-5 is in the
OFF position, the Test Print cycle must be initiated with a Print Start signal on the EXT
connector You enter the Test Print Mode by pressing the FEED key while powering the printer
on..
ADVANCED MODE The Counter Mode is accessed from the Advanced Mode. Press
the Cursor keys to step to the Counter Mode.
COUNTERS MODE Pressing the ENTER key will advance the display to the counter
selections.
COUNTERS
HD CUT LIFE
The counters are identified in the display as:HD:Head Counter
(should be reset when print head is replaced)
HD: Head Counter
CUT: Cutter Counter
LIFE: Life Counter (cannot be reset)
1. Use the Cursor keys to step the cursor to the desired
counter, the Head (HD) counter or the LIFE counter. The
default position is the Head Counter. Use the Cursor keys to
advance the cursor to the desired selection.
HEAD COUNTER
0.5M
2. Once the correct setting is selected, pressing the ENTER
key will display the current value (in meters) stored in the
counter. The maximum number of digits displayed is 8.
3. Pressing the ENTER key again will advance the counter to
the Clear mode. All counters with the exception of the LIFE
counter may be cleared.
HEAD COUNT CLEAR
YES NO
4. Use the Cursor keys to select the desired setting. If you only
wanted to read the counter value, select NO. If you want to
read the counter and reset it to 0.0, place the cursor over the
YES. Once the desired setting is selected, pressing the
ENTER key will advance the return you to the Counters
Mode display.
COUNTERS MODE 5. To exit the Counters Mode, turn power to the printer off and
then back on.
V 05.00.03.00
INITIALIZING
Displays the firmware during the initialization.