Filter
Top Products
66
ENGLISH
Unlocking Menus Before Programming
Level of access / Operating mode
The position of the selector switch offers three levels of access to the menus according to the operating phase
of your machine. Access to the menus can also be locked using an access code (see the Files menu).
Position Display : use during operating phases
- LANGUAGE menu : To select the dialog language
- MACRO-CONFIG menu : To display the macro-configuration
-IDENTIFICATION menu : To display the speed controller voltage and power
-DISPLAY menu : To display the electrical values, the operating phase or a fault
Position Display and settings : use during setup phases
- To perform all the operations which are possible in level 0
- ADJUST menu : To set all the parameters which can be accessed while the motor is rotating
Position Total unlock : use during programming phases
- To perform all the operations which are possible in levels 0 and 1
- MACRO-CONFIG menu : To change the macro-configuration.
- IDENTIFICATION menu : To change the power in "standard torque" or "high torque" mode, for the ratings
governed by this parameter.
- DRIVE menu : To adjust the performance of the motor-speed controller unit
- CONTROL menu : To configure control of the speed controller, for control via the terminals, the display
module or the integrated RS485 serial link
- I/O menu : To change the I/O assignment
- FAULT menu : To configure the motor and speed controller protection and behavior in the event of a fault
- FILES menu : To save and restore the speed controller configurations stored in the display module, return
to the factory settings or protect your configuration
- COMMUNICATION menu, if a communication card is installed : To adjust the parameters of a
communication protocol
- APPLICATION menu, if a «client application» card is installed. Please refer to the documentation specific
to this card.
GP_ATV58_EN.fm Page 66 Mardi, 2. avril 2002 6:09 18