Filter
Top Products
88
ENGLISH
I/O Menu
This menu can be accessed when the switch is in position .
The assignments can only be modified in stop mode with the speed controller locked.
The inputs and outputs available in the menu depend on the I/O cards installed (if any) in the speed controller,
as well as the selections made previously in the control menu.
The “factory” configurations are preassigned by the selected macro-configuration.
Summary table of the configurable input assignments (exc. 2-wire / 3-wire option)
CAUTION: If a logic input is assigned to "Freewheel stop" or "Fast stop", start-up can only be
performed by linking this input to the +24V, as these stop functions are active when inputs are at
state 0.
Code Function
LL
LL
II
II
22
22
LI2 Assign.
See the summary table and description of the functions
I/O extension option cards 2 logic inputs LI5-LI6
Speed controller without option 3 logic inputs LI2 to LI4
NO:Not assigned
(Not assigned) X
RV :Reverse
(Run reverse) X
RP2:Switch Ramp2
(Ramp switching) X
JOG
(Jog operation) X
+SP: + Speed
(+ speed) X
-SP: - Speed
(- speed) X
PS2: 2 Preset SP
(2 preset speeds) X
PS4: 4 Preset SP
(4 preset speeds) X
PS8: 8 Preset SP
(8 preset speeds) X
RFC:Auto/manu
(Reference switching) X
NST:Freewhl Stop
(Freewheel stop) X
DCI:DC inject.
(Injection stop) X
FST:Fast stop
(Fast stop) X
CHP:Multi. Motor
(Motor switching) X
TL2:Trq.Limit 2
(Second torque limit) X
FLO:Forced Local
(Forced local mode) X
RST:Fault Reset
(Clearing faults) X
ATN:Auto-tune
(Auto-tuning) X
PAU:PI Auto/Manu
(PI Auto/Manu) If one AI = PIF X
PR2:PI 2 Preset
(2 preset PI setpoints) If one AI = PIF X
PR2:PI 4 Preset
(4 preset PI setpoints) If one AI = PIF X
TLA:Torque limit
(Torque limitation by AI) If one AI = ATL X
EDD:Ext flt.
(external fault) X
GP_ATV58_EN.fm Page 88 Mardi, 2. avril 2002 6:09 18