Filter
Top Products
106
ENGLISH
Files Menu
Files menu (continued)
The speed controller configuration can be protected by a password (COd).
CAUTION : THIS PARAMETER SHOULD BE USED WITH CAUTION. IT MAY PREVENT ACCESS TO ALL
PARAMETERS. ANY MODIFICATION TO THE VALUE OF THIS PARAMETER MUST BE CAREFULLY
NOTED AND SAVED.
The code value is given by four figures, the last of which is used to define the level of accessibility required by
the user.
Access to the menus according to the position of the access locking switch on the rear of the display module
is always operational, within the limits authorized by the code.
The value Code 0000 (factory setting) does not restrict access.
The table below defines access to the menus according to the last figure in the code.
For access to the APPLICATION menu, refer to the application card documentation.
The code is modified using the
▲
and
▼
keys.
If an incorrect code is entered, it is refused and the following message is displayed :
After pressing the ENT or ESC key on the keypad, the value displayed for the Code parameter changes to
0000 : the level of accessibility does not change. The operation should be repeated.
To access menus protected by the access code the user must first enter this code which can always be
accessed in the Files menu.
Code Description
CC
CC
OO
OO
dd
dd
Password
Confidential code
Last figure in the code
Menus Access locked Display Modification
Adjust 0 exc. 0000 and 9 1 2
Level 2 :
Adjust, Macro-config, Drive, Control, I/O, Fault,
File (excluding code),
Communication (if card present)
0 exc. 0000 and 9 3 4
Application (if card present) 0 exc. 0000 and 9 5 6
Level 2 and Application (if card present) 0 exc. 0000 and 9 7 8
8888
This figure gives the access level
permitted, without having the correct code.
Password Fault
COd
GP_ATV58_EN.fm Page 106 Mardi, 2. avril 2002 6:09 18