Filter
Top Products
37 | CHAPTER 5 – REMOTELY MANAGING YOUR SMART BOARD 600I3 OR
SBD600I3 INTERACTIVE WHITEBOARD SYSTEM
NOTES
• All commands should be in ASCII format. Terminate all commands with a
carriage return.
• All responses from the ECP are terminated with a carriage return line feed
combination followed by a command prompt. Wait until you receive the
command prompt indicating that the system is ready for another command
before proceeding.
• The room control feature of your projector is always on.
To configure
your computer’s
serial interface
1. Turn on your computer, and then start your serial communications program or
terminal emulation program.
2. Connect your computer to the ECP’s serial connector using a DB9 cable.
CAUTION
Do not connect your serial cable directly to the projector’s RS-232 serial
interface. Use ECP’s RS-232 serial interface only.
3. Configure your serial interface settings using the values in the table in the
previous section, and then press ENTER.
An “invalid cmd= ? for help” message appears, and the > character appears as a
command prompt on the following line.
NOTE
If no message or an error message appears, your serial interface
configuration isn’t correct. Repeat step 3.
4. Type commands to configure your settings.
NOTES
– To see a list of available commands, type ? and then press ENTER.
– When you’re using a terminal emulation program, turn on your program’s
local echo setting if you want to see characters as you type them.
Stop Bits 1
Flow Control None
Setting Value