Filter
Top Products
58 | CHAPTER 8 – REPLACING YOUR UF55/UF55W PROJECTOR LAMP
• If the lamp has shattered or burst:
– Call your authorized SMART reseller
for instructions. Do not attempt
to replace the lamp.
– Do not touch the glass fragments because they might cause injury.
– Leave and then ventilate the area where the lamp shattered or burst.
– Wash your hands thoroughly if you have come in contact with
lamp debris.
– Thoroughly clean the area around the projector, and then discard any
edible items placed in that area because they might be contaminated.
• You must remove the projector from the projector’s boom before servicing
the lamp.
– Replacing the lamp in a boom-mounted projector might result in a fall
or injury.
– Uncovering the lamp while the projector is mounted on the boom might
lead to product damage or personal injury from falling pieces of glass if
the lamp is broken.
• When replacing the projector lamp:
– Turn the projector off and wait 30 minutes for the lamp to cool completely
before removing the projector from the boom.
– Do not remove any screws other than those specified in the lamp
replacement instructions.
– Wear protective eyewear while changing the lamp. Failure to do so can
cause injury or loss of eyesight if the lamp shatters or bursts.
– Use only replacement lamps approved by SMART Technologies. Contact
your authorized SMART reseller
for replacement parts.
– Never replace the lamp assembly with a previously-used lamp assembly.
– To prevent premature lamp failure or exposure to mercury, always handle
the fragile lamp assembly with care. Use gloves when touching the lamp.
Do not touch the lamp with your fingers.
– Recycle or dispose of the lamp as hazardous waste, in accordance with
local regulations.
• When returning the projector to the boom, replace all of the screws that you
removed when you removed the projector. Failure to do so can result in the
projector falling from the boom, causing injury or equipment damage.