Filter
Top Products
64 | CHAPTER 8 – REPLACING YOUR UF55/UF55W PROJECTOR LAMP
4. Connect all cables to the projector, and then attach the cable cover.
5. Replace the cover on the top of the boom.
6. Replace and tighten the screw until it’s secure, without applying pressure or
weight to the projector boom.
7. Connect the power cord to the wall power outlet, and then wait for the projector
to turn on completely.
8. If required, re-adjust the projected image. See page 15.
Resetting the Lamp Timer
After you replace the lamp, reset the lamp timer.
To reset the lamp timer 1. Press the power button on the extended control panel (ECP) or the remote
control to start your interactive whiteboard system.
The ECP’s power light turns solid green when the system starts.
2. Wait five minutes for the projector to warm up.
3. Press DOWN, UP, UP, LEFT, UP (DUULU) on the remote control to access the
service menu.
4. Using the remote control, select the Lamp Hour Reset option, and then
press OK.
Both Lamp Hour values (Standard and Economy) are reset to zero.
NOTE
You’re unable to reset the Display Hour value because it’s the running total of
hours that the projector has been in use.
5. Press the Menu button on the remote control.
The SMART UF55 Settings menu appears.
6. Select to confirm that Lamp Hours has been reset to zero.
Your system is ready for use.