Filter
Top Products
43 | CHAPTER 5 – REMOTELY MANAGING YOUR SMART BOARD 600I3 OR
SBD600I3 INTERACTIVE WHITEBOARD SYSTEM
Network Information
The Network Information commands enables you to display various types of
network information.
Command Response Powered off
get netstatus netstatus=[current] yes
set dhcp dhcp=[current] yes
get dhcp dhcp=[current] yes
set ipaddr ipaddr=[current] yes
get ipaddr ipaddr=[current] yes
set subnetmask subnetmask=[current] yes
get subnetmask subnetmask=[current] yes
set gateway gateway=[current] yes
get gateway gateway=[current] yes
set primarydns primarydns=[current] yes
get primarydns primarydns=[current] yes
get macaddr macaddr=[current] yes
Field Possible Values Description
current netstatus connected
disconnected
Displays the current state of the
network interface
current dhcp on
off
Displays whether the DHCP
networking is enabled or disabled
target dhcp =on
=off
Displays whether the DHCP
networking is enabled or disabled
current ipaddr x.x.x.x Displays the current IP address
target ipaddr x.x.x.x Displays the target IP address
(only if dhcp=off)
current subnetmask x.x.x.x Displays the current subnet mask
target subnetmask x.x.x.x Displays the target subnet mask
current gateway x.x.x.x Displays the current gateway
target gateway x.x.x.x Displays the target gateway
current primarydns x.x.x.x Displays the current primary DNS
target primarydns x.x.x.x Displays the target primary DNS
MAC address x-x-x-x-x-x Displays the device’s MAC
address.