Filter
Top Products
69 | MOUNTING YOUR INTERACTIVE WHITEBOARD ON A FLOOR STAND
Other Tools and Parts Required
To mount your SMART Board interactive whiteboard on a floor stand, you’ll also need
the following tools and parts, which aren’t included with your floor stand:
• a Phillips No. 2 screwdriver
• a 7/16" (11 mm) wrench
• three small thread-forming screws
(included with your SMART Board V280
interactive whiteboard)
NOTE
You’ll need the help of another person
to mount your interactive whiteboard
on a floor stand.
To mount your
interactive whiteboard
on an FSV280 floor stand
1. Hook the blunt end of each upright brace (A)
into the left and right feet (B and C), and then
guide the opposite hooked end of each brace
(A) into the left and right uprights (D and E),
as illustrated.
2. Align each foot until it’s perpendicular
to its corresponding upright, and then secure
them with two 1 1/2" (3.8 cm) button-head
screws (K). Use the included hex key to tighten
the screws.
zz
(×3)
#2
7/16"
(11 mm)
i
A
C
E
ii
D
A
B
B
D
C
E
K
4×