Filter
Top Products
Select character table
<ESC>
t Cn>
Both
1Bh
74h Cn>
27 116
<FS> I
<n>
<n>
Standard
1Ch 49h
<n>
28 73 Cn>
The command above will select the character table to be used in subsequent printing,
where vt> can be a binary or ASCII value from OOh through 02h or “0” through “2”.
The following table shows the effect of this parameter:
Cl
Moves character set downloaded in OOh to 7Fh area to
Any other values are invalid and will be ignored.
Select primary character set
<ESC>
7
Both
1 1Bh 37h
27 55
The command above selects the primary character set.
There are no parameters. The area 6om 8Oh to 9Fh is used for control codes.
Select secondary character set
<ESC> 6
Both
1 27
The command above selects the secondary character set.
There are no parameters. The area from 8Oh to 9Fh is used for printable characters.
28