Filter
Top Products
I
Enable unidirectional prlntlng for one line only
cEsc>
C
Both
60
I
The command above enables unidirectional printing for one line. only. There are no
parameters. printing will be performed from left-to-right for the current line only.
Enable/disable quiet mode
cEsc> S
C?D
1Bh 73h
<n>
27
115
<rD
Both
The command above enables or disables quiet mode, where <n> is a binary value of
either Oh or Olh or an ASCII value of either “0” or “1”. If cn> is set to OOh or “O”,
thenquietmodeisdisabled,andif<n>issettoOlhor“l”,thenquietmodeisenabl~.
This command overrides the Memory Switch settings or the setting made from the
frontpanel.Quietmodemeanstbateachcharacterisprintedintwopassesoftheprint
head.
Enable/disable large character printing
<ESC>
h
<n>
1Bh 68h
<rD
27 104
Cn>
Both
‘Me command above enlarges characters, or cancels such enlargement, where cn>
is a binary value of OOh through 02h or an ASCII value of ‘0” through “2”. If UP
is set to OOh or 9”. then any character enlargement is cancelled. If vu is set to 01 h
or “1”. then characters are printed at double height and width. If cn> is set to 02h or
“2”. then characters are printed at quadruple height and width. It is the user’s
responsibility to alter the line pitch,so that it is in accordance with the new character
height, and to produce a line feed at the new pitch in order to leave sufficient space
for the new characters. If thereare different sizes of print on the same line, the
printing will be aligned along the top of the characters. Any previous commands for
enlargement (vertical or horizontal) of characters will be cancelled by this com-
65