Star Micronics XB24-15 Printer User Manual


 
Reset
<ESC>
1Bh
27
cFs>
@
40h
64
@
Both
Standard
1Ch 40h
28 64
The command above resets the printer. There are no parameters. On receipt of this
command, the buffer is cleared, and all settings (with the following exceptions) are
restored to their power-up values.
l ASF settings made with the cESC> EM command
l Panel mode settings
ASF (Automatic Sheet Feeder) control
&SC>
CEW
C?P
Both
1Bh 19h
27 25
<n>
C?D
The command above controls the operation of the ASF, where <EM> is the ASCII
code 19h, and QD may take the binary values OOh or 04h or the ASCII values “R”
or “T’. The effect of these values is summarized below:
Value Effect
OOh 1 Selectmanualmode
04h
Select auto mode
“R”
Eject paper
‘T”
Set top print position. This parameter must be
followed by anot+ binary value (>l) signify-
ing the ditance (m l/6 inch units) at which
printing should start below the top of the paper.
These commands will be ignored if the ASF has not been selected.
66