Filter
Top Products
4-22 Sun Netra CP3240 Switch Installation Guide • September 2009
4.10.5 Default Settings
The switch comes configured with a default configuration. This configuration boots
the board to Layer 2 switching. This configuration is very basic and should be
updated for your environment. The default settings are as follows:
■ every port is in VLAN 1
■ every port is configured in switching mode
■ management interfaces are enabled
■ spanning-tree is enabled on every port
■ everything else is disabled
The settings of the switch can be checked with the show running-config
command. This command shows how the current configuration is different than the
default configuration. This command can be very useful because the output is in
script format. This output can be backed up or copied to another switch.
4.10.6 Port Ordering
The ports are ordered the same way as the ATCA channels. The ATCA specification
allows for backplanes to be routed differently. This means that logical slots and
physical slots often do not match.
The switch supports an abstraction layer that allows the port order to be changed.
This allows vendors to match logical slots and physical slots independent of routing.
Contact Sun if you would like a non-standard port order. Sun’s port ordering is
shown in the following table for shelves with middle hub slots, that is, slots 7 and 8.
lineconfig
no transport input telnet
exit
ip http secure-server
no ip http server
TABLE 4-7 Port Order List
Shelf Physical Slot Base Port Fabric Port
11312
21110