Filter
Top Products
Chapter 4 Configuring Switch Software 4-15
9. Press number 1 to boot the system.
CODE EXAMPLE 4-5 Example Console Output
CPU: 400 MHz
DRAM: 256 MB
FLASH: 64 MB, Base, Primary Flash
### JFFS2 loading 'image1' to 0x400000
Scanning JFFS2 FS: . done.
### JFFS2 load complete: 10026500 bytes loaded to 0x400000
Booting ...
Loading Ramdisk to 0fdf6000, end 0ff8d4c2 ... OK
Mounting /dev/mtdblock2 at /mnt/fastpath...done.
Mounting tmpfs at /mnt/application...done.
*****************************************************************
***
* Use the [`] key above the TAB to switch between BASE and FABRIC. *
*****************************************************************
***
switch, Base, Primary Flash, image1
Select startup mode. If no selection is made within 5 seconds,
the Application will start automatically...
--- Main Menu ---
1 - Start Switch Application
2 - Display Utility Menu
Select (1, 2): 2
*****************************************************************
***
* Use the [`] key above the TAB to switch between BASE and FABRIC. *
*****************************************************************
***
switch, Base, Primary Flash, image1
--- Utility Menu ---
1 - Start Switch Application
2 - Load Code Update Package using TFTP/FTP
3 - Load Code Update Package using XMODEM/YMODEM/ZMODEM
4 - Copy Primary Flash to Backup Flash
5 - Select Serial Speed