Filter
Top Products
xvi Sun Netra CP3240 Switch Installation Guide • September 2009
TABLE 3-3 P6 (1-2) Fabric Zero Reset Jumper Settings 3–3
TABLE 3-4 P6 (3-4) Base Zero Reset Jumper Settings 3–3
TABLE 3-5 P8 (1-2) Base Write-Protect Jumper Settings 3–3
TABLE 3-6 P8 (3-4) Fabric Write Protect Jumper Settings 3–4
TABLE 3-7 P9 IPMC Firmware Program Jumper Settings 3–4
TABLE 3-8 P10 (1-2) IPMC Reset Jumper Settings 3–4
TABLE 3-9 P10 (3-4) IPMC FWE Reserved Jumper Settings 3–5
TABLE 3-10 P11 (1-2) Forced-Board Enable Jumper Settings 3–5
TABLE 3-11 P11 (3-4) IPMC Board Reset Jumper Settings 3–5
TABLE 3-12 P12 (1-2) and P12 (3-4) Grounding Jumper Settings 3–6
TABLE 3-13 P13 Serial Direction Jumper Settings 3–6
TABLE 4-1 IPMI State Sensors 4–2
TABLE 4-2 0 4–2
TABLE 4-3 IPMI Sensor Logic 4–3
TABLE 4-4 IPMI Thresold Sensors 4–4
TABLE 4-5 uBoot Console Commands 4–6
TABLE 4-6 Basic CLI Commands 4–19
TABLE 4-7 Port Order List 4–22
TABLE A-1 Absolute Maximum Electrical and Temperature Ratings A–2
TABLE A-2 Normal Operating Electrical and Temperature Ratings A–2
TABLE A-3 Board Dimensions and Weight A–3
TABLE B-1 Connector Assignments B–2
TABLE B-2 ATCA Zone 1 Connector (J9) Pins B–4
TABLE B-3 ATCA Zone 2 P20 ZD Connector (J5) B–5
TABLE B-4 ATCA Zone 2 P21 ZD Connector (J4) B–6
TABLE B-5 ATCA Zone 2 P22 ZD Connector (J3) B–6
TABLE B-6 ATCA Zone 2 P23 ZD Connector (J2) B–7
TABLE B-7 ATCA Zone 2 P24 ZD Connector (J1) B–8
TABLE B-8 Serial RJ-45 Connector (J13-Top) B–8
TABLE B-9 Minimum Serial Cable Pinouts B–9