Filter
Top Products
D 13373.08
NOVEMBER 2007
MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
QoS Conguration
QoS (Quality of Service) Conguration
QoS Configuration (network 1-2)
The network must support Quality of Service (QoS) for these
settings to work. You can configure the Quality of Service
mode differently for Network #1 and Network #2.
Network Configuration
QoS Mode (network 1-2)
Precedence: Select IP Precedence QoS method and see
QoS Mode Configuration for details.
Diffserv: Select Diffserv QoS method and see QoS Mode
Configuration for details.
Off: No QoS is used.
Save - Press the Save button to save changes.
QoS Type of Service Priority
Minimum Delay: Will choose a route where minimum delay is
prioritized.
Maximum Throughput: Will choose the route with highest
bandwidth is prioritized.
Maximum Reliability: Will choose the route where minimum
packet loss is prioritized.
Minimum Cost: Will choose the cheapest connection avail-
able.
Off: Quality of Service not active.
QoS Mode Configuration
Diffserv• is used to define which priority audio, video,
data and signalling packets should have in an IP network.
The priority ranges from 0 to 63 for each type of packets.
Precedence• is used to define which priority audio, video,
data and signalling should have in an IP network. The
higher the number, the higher the priority. The priority
ranges from 0 (Off) to 7 for each type of packets.
In addition to Precedence, • Type of Service can be used
and enables the user to define what type of connec-
tion that should be chosen for the IP traffic. This helps
a router select a routing path when multiple paths are
available.
104
Introduction
Quick
Setup
Using
the MPS
System
Status
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices
Main
System
Configuration