D 13373.08
NOVEMBER 2007
MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
MCU Overview > Create Conference
Password
To ensure only authorized participants are able to join this
conference you can set a password. Then the participants
must enter the password to join this conference. The pass-
word can be numerical only.
When dialling into a password protected conference, the •
participant is met with the ‘Password Enquiry’ screen and
sound, asking the participant to enter a password. This
can be performed via a menu generated by the videocon-
ferencing system (H.243 Password) or via DTMF (tele-
phone) tones.
Until the correct password is entered, the participant will •
not be able to hear or see any of the other participants.
After entering the correct password and confirming (typi-
cally by pressing ‘OK’ or the hash key), the participant will
join the conference.
Should the password be incorrect, the participant is met •
with the ‘Password Incorrect’ screen and after a few
seconds, the ‘Password Enquiry’ screen and sound appear
again. If the participant enters a wrong password three
times, the participant will be disconnected.
With no password entered in this field, participants can •
join the conference without entering a password
Password Out
On: When set to On and dialling out from a password pro-
tected conference, the participant is met with the ‘Password
Enquiry’ screen and sound, asking the participant to enter a
password. This setting can be used to ensure that only autho-
rized participants are able to join the conference also when
dialling out from the conference.
Off: When set to Off no password is required when dialling
out.
Create Only
Select Create Only to create a confer-
ence, with the above-specified configura-
tion, without dialling out to any partici-
pants.
Add Participants
Select Add Participants to add participants
or to manually dial a participant.
Cancel
Select Cancel to discard all changes and
return to the Conference Overview page.
Security Settings (1:2)
48
Introduction
Quick
Setup
System
Status
System
Configuration
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices
Main
Using
the MPS