Filter
Top Products
D 13373.08
NOVEMBER 2007
MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
Conguring LCS and MPS for SIP (5:6)
MPS SIP Configuration
SIP Configuration
To configure the MPS for SIP communication, navigate to System Con-
figuration > SIP:
Set 1. SIP Mode to On
Configure the Interface for SIP communication. Enter the 2. DNS Name
or IP Address for the SIP server in the Address field and set the SIP
Server Type to Microsoft
Press the 3. Save button and restart the MPS for all changes to take
affect.
Please refer to section System Configuration > SIP Configuration
for more details.
Configuring the MPS
The Microsoft Live Communication Server (LCS) should be config-
ured prior to the MPS unit.
The MPS configuration consists of ensuring the MPS has a valid DNS
name server configured and entering the LCS server information.
DNS Server Configuration
The LCS SIP operation requires the MPS to have a valid DNS (Domain
Name System) server configured.
If the DNS server is not configured properly, calls may connect to
the MPS, but neither video nor audio will be transmitted to the far
end.
!
MS Live Communications Server
177
Introduction
Quick
Setup
Using
the MPS
System
Status
System
Configuration
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Main
Appendices