Filter
Top Products
D 13373.08
NOVEMBER 2007
MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
Conference Template
Conference Conguration (2:2)
Conference Template Configuration
The Conference Templates are found in the MCU Configuration tab.
The predefined settings will be used as default settings when creating
new conferences based on this specific template. TANDBERG MPS
enables the setup of 10 different conference templates.
The conference template contains the same settings as de-
scribed in the Create Conference in the Overview section.
Conference Template Configuration
Maximum Call Duration
Determines the maximum duration (minutes) of the conference.
All sites will be disconnected when the specified ‘Max Call Dura-•
tion’ has been reached.
10 minutes, five minutes and one minute prior to this, a warning •
will be displayed to all the video participants in the conference,
indicating the remaining time.
The conference will remain active, after having timed out, allowing •
sites to dial in again and restart the conference timer.
The conference administrator can extend the time. •
The timer for the max call duration will not begin until the first •
participant is connected.
Legacy Level
When connecting older videoconferencing endpoints to the MCU,
problems can occur since older equipment sometimes do not handle
modern capabilities.
When set to 0-7: All capabilities are sent from the MCU•
When set to 8-14: The H.264 is disabled. •
When set to 15: The only capabilities sent for level 15 are H.261, •
G.711 and G.722.
Floor to Full Screen
On: When set to On, the participant requesting the floor will
be shown in full screen to all the other video participants,
regardless of current speaker. The same will happen if the
conference administrator assign floor to a site.
Off: When set to Off, the participant requesting the floor
will be shown in the largest sub-picture if there is one in the
selected layout.
Billing Code
When defining a conference, a specific billing code can be
assigned to the conference.
All calls in this conference will be associated with this
billing code. This will allow management tools, such as the
TANDBERG Management Suite, to use the code for billing
purposes.
Press Save to activate the new settings
132
Introduction
Quick
Setup
Using
the MPS
System
Status
System
Configuration
Installation
Gateway
Configuration
Technical
Descriptions
Appendices
Main
MCU
Configuration