Filter
Top Products
D 13373.08
NOVEMBER 2007
MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
Add a Route
When the MPS is configured as an Authorized Host to
the LCS, the LCS needs to be told what SIP URIs should
be forwarded to the MPS. This is done by configuring a
route in the Live Communocation Server.
The SIP URI to reach the MPS will be the combination of
the User and Domain fields.
Under the same server properties window (see previ-
ous page), select the Routing tab and press Add… to
open the Add Static Route dialog and add a new routing
pattern:
The 1. User field is used to specify which URIs will be
forwarded by this rule. Wildcards (*) are allowed.
In the 2. Domain box, enter the domain that will be used
with the SIP URI for the MPS. The SIP URI to reach
the MPS will be the combination of the user and
domain fields. Example: <MPS@company.com>
Under 3. Next Hop, select IP Address and enter the IP
address of the System Controller Board of the MPS.
Set 4. Transport to TCP
Set 5. Port to 5060.
Press the 6. OK button to save the route
Press the 7. OK button to close the properties window
of the server.
This completes the configuration of the LCS server.
Next, the MPS will need to be configured to use the LCS
server.
Configuring Microsoft Office Live Communications Server (LCS) 2005, SP1
This section will illustrate how to setup the Live Commu-
nication Server (LCS) to work properly with the MPS.
Example #1:
If you want all calls coming in to <MPS> to be forwarded to the MPS, enter <MPS> in the User field.
LCS does allow a wildcard entry. Enter the <*> character if a wildcard entry is desired. For example, if all calls beginning with <MPS> should
be forwarded to the MPS itself (e.g. <MPS123@lcs.int>, <MPS456@lcs.int>, <MPSConference2@lcs.int>), then enter <MPS*> in the
user field.
In the Domain box, enter the domain that will be used with the SIP URI for the MPS. The complete SIP URI to reach the MPS will be the
combination of the user and domain fields. Example: <MPS@company.com>
Under Next Hop, select IP Address and enter the IP address of the controller card of the MPS. Make sure Transport is set to TCP and Port
is 5060. The completed route should look like the figure to the left. Press OK to save the route, and press OK again to close the Properties
window of the server.
Conguring LCS and MPS for SIP (3:6)
MS Live Communications Server
175
Introduction
Quick
Setup
Using
the MPS
System
Status
System
Configuration
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Main
Appendices