Filter
Top Products
D 13373.08
NOVEMBER 2007
MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
MCU Overview > Create Conference
Video Participant Limit
Defines the maximum number of Video Participants allowed in
the conference and reserves the number of needed Advanced
Video Option ports for this conference.
Values: 0 - 40 for MPS 200 and 0 - 160 for MPS 800.
Telephone Participant Limit
Defines the maximum number of Telephone Participants al-
lowed in the conference.
Values: 0 - 32 for MPS 200 and 0 - 48 for MPS 800.
Welcome Picture and Sound
On: When set to On a Welcome screen and audio message
will be shown to each new participant of the conference.
Off: Set to Off to disable the Welcome screen and audio mes-
sage.
Entry and Exit Tones
On: When set to On a tone signal will be heard each time a
participant is entering or leaving the conference.
Off: Set to Off to disable the Entry and Exit Tones.
Timeout Participants from Call List
On: When set to On all participants that have been discon-
nected from the conference will be cleared from the Call List
within 2 minutes.
Off: Set to Off to disable the Timeout Participants from Call
List.
Create Only
Select Create Only to create a confer-
ence, with the above-specified configura-
tion, without dialling out to any partici-
pants.
Add Participants
Select Add Participants to add participants
or to manually dial a participant.
Cancel
Select Cancel to discard all changes and
return to the Conference Overview page.
Participants Settings
50
Introduction
Quick
Setup
System
Status
System
Configuration
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices
Main
Using
the MPS