Filter
Top Products
D 13373.08
NOVEMBER 2007
MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
PRI Board
Network Configuration
PRI Board in Slot 1-n (1:3)
HLC
On: Enables sending of HLC (High Level Compatibility) infor-
mation element in setup message (video calls only).
Off: Disables sending of HLC information element in setup
message (video calls only), (Default: Off).
Parallel Dial
On: Channels will be dialed and connected in parallel when
setting up a BONDING call (Default: On).
Off: Channels will be dialed sequentially, which may in-
crease setup time.
Send Number
On: The TANDBERG MPS will send its own number to the far
end. This is only useful when each conference have specified
a Dial In number (Default: On).
Off: The TANDBERG MPS will not send its own number to
the far end. Please note that the network may still send your
number to the far end.
Send Complete
On: The TANDBERG MPS will send the ISDN message infor-
mation element <Sending Complete> in the outgoing call
Setup message. This is only required in a few countries.
Off: The TANDBERG MPS will not send <Sending Com-
plete> (Default: Off).
PRI Board Configuration
Please ensure that Network Type is set to PRI for the
correct ISDN cards in the PRI Network Configuration.
!
Save - Press the Save button to save changes.
88
Introduction
Quick
Setup
Using
the MPS
System
Status
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices
Main
System
Configuration