Filter
Top Products
D 13373.08
NOVEMBER 2007
MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
MCU Overview > Create Conference
Encoder Selection Policy
Best Bit Rate: Set to Best Bit Rate to make the MPS prioritize
the video quality for sites based on bit rate.
The system will move participants with a Low Video Rate to a
secondary encoder, if it is available. If no sites are moved, the
system will move sites with Low Video Standard.
Best Video Standard: Set to Best Video Standard to make
the MPS prioritize sites based on video standard.
The system will move participants with a Low Video Stan-
dard to a secondary encoder, if it is available. If no sites are
moved, the system will move sites with Low Video Rate.
Best Resolution: Set to Best Resolution to make the MPS
prioritize the video quality for sites based on resolution.
The system will move participants with a Low Resolution to a
secondary encoder, if it is available. If no sites are moved, the
system will move sites with low video rate.
Web Snapshots
The web snapshots are shown in the upper right corner of
the web interface, and will show snapshots of the video from
the participants and dual video stream. The snapshots are
updated in accordance to the refresh rate (placed above the snapshot).
On: Set to On to enable Web Snapshots. When set to On the Conference Snapshot
and Dual Video Stream Snapshot will show the video transmitted from the MCU to the
participants.
Off: When set to Off a picture will appear telling that the Web Snapshots are disabled.
Secondary Rate
On: Set to On to enable Secondary Rate. The conference will
support two outgoing bandwidths if needed, in addition to the
low rate video.
Off: Set to Off to disable Secondary Rate.
Create Only
Select Create Only to create
a conference, with the above-
specified configuration, without
dialling out to any participants.
Add Participants
Select Add Participants to add
participants or to manually dial a
participant.
Cancel
Select Cancel to discard all
changes and return to the Con-
ference Overview page.
Video Settings (5:5)
Optimal Voice Switch
On: Set to On to enable Optimal video format in Voice Switch
mode, if the connected endpoints allows this.
Off: When set to Off there will be normal transcoding when
doing Voice switch.
Optimal Voice Switch is only available on IP.1.
Icons and text are not available when set to On.2.
!
46
Introduction
Quick
Setup
System
Status
System
Configuration
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices
Main
Using
the MPS