Filter
Top Products
4.17 Wireless LAN Antenna/Display Cover/Speaker 4 Replacement Procedures
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445) 4-63
10. Set the left and right speakers on the back of the display assembly and secure the
speakers with the following screws.
• M2.5x5 THIN BIND screw x5 (Left: 2, Right: 3)
CAUTION: When installing the speakers, be careful not to touch the metal part of the
speakers. It might damage the speakers.
11. Hook the right speaker cable (Red) on two guides and pass it around the hinge cover.
Stick the insulator on the back of the display assembly.
12. Hook each speaker cable (Red, Blue) on the guides respectively. Pass the connector
part of the cables under the insulator and stick the glass tape on the cables.
13. Hook the wireless LAN antenna cables on the guides. Pass the cables toward the front
of the display assembly and stick the acetate tape to secure the cables. Then pass the
cables toward back side again and hook on the guide. Pass the cables over the
wireless LAN slot.
14. Install the latch assembly on the display cover.