Filter
Top Products
3.MAIN UNIT REPLACEMENT
EO18-33016A
3.5 Ribbon Motor/Ribbon Sensor
3-12
<Tip>
When removing the Ribbon Motor or the Ribbon Sensor only, step 6 to step 12 can be omitted.
It can be removed by just disconnecting each cable and removing the screw.
6. Disconnect the Ribbon Motor Connectors and Ribbon Sensor Harness.
7. Remove the two screws to release the ground wires (brown and black).
8. Remove the three screws to detach the Ribbon Motor Drive Unit.
9. Remove the screw to detach the Ribbon Motor Unit.
Ground Wire (Brown)
FLT-3x8 Screw
Ribbon Motor
Drive Unit
Ribbon Motor Unit
PT-3x8 Screw
Ribbon Sensor Harness
Ribbon Sensor Harness
Ground Wire (Black)
Ribbon Motor Connector
Ribbon Motor Connecto
r
PT-3x10 Scre
w
PT-3x8 Scre
w
PT-3x8 Screw