Filter
Top Products
1. UNPACKING
EO18-33016A
1.2 Checks
1- 2
1.2 Checks
1. Check for damage or scratches on the printer.
2. Confirm that none of the accessories are missing. The parts below are provided as accessories.
(B-SA4TM only)
NOTE: Keep the carton and pads for later transport.
2. PRINTER INSTALLATION
1. Place the printer on the level surface.
2. Keep enough space for replacing and maintenance works while the top cover is opened.
Warranty Disclaimer Sheet
Supply Loading Instructions
(Doc. No. EO2-33015 for B-SA4TM)
(Doc. No. EO2-33017 for B-SA4TP)
CD-ROM
Safety Precautions
(Doc. No.: EO2-33016)
Quality Control Report
Printer Rear Support
SMW-4x8 Screw
Cable Clamp
SMW-3x8 Screw
30 mm
300 mm
30 mm
300 mm
700 mm
300 mm
75 mm
CAUTION!
When installing the printer, take the following
p
recautions. Failure to do this may cause fire,
electric shock, or injury.
1. Avoid locations where it is subject to the
following:
• Direct sunlight
• High temperature, high humidity
• Rapid change in temperature
• Excessive vibration
• Dust
2. Keep away from any devices that emit
magnetism or electromagnetic wave.
3. Keep away from flame or moisture.
4. Be sure to place the printer on a level an
d
stable surface.
5. As the enclosure of the B-SA4TP model is
made from plastic, do not install the printe
r
where it might be exposed to oil or solvent.