Filter
Top Products
3.MAIN UNIT REPLACEMENT
EO18-33016A
3.10 Media Sensor
3-22
3.10 Media Sensor
1. Open the Top Cover.
2. Slightly push the Upper Sensor Lever inside, and open the Upper Sensor Ass’y.
3. Pushing the tabs on the rear of the Media Sensor Block toward the front of the printer, slightly lift the
back of the Media Sensor Block, and remove it toward the printer back.
4. Move the upper and lower Media Sensors to the left end, then, disconnect the Sensor Harnesses.
(Upper sensor: White, Lower senor: Yellow)
Upper Sensor Lever
Upper Sensor Ass’y
Upper Sensor
Harness (White)
Lower Sensor
Harness (Yellow)
Media Sensor
Media Sensor Block
Tab