Filter
Top Products
3.MAIN UNIT REPLACEMENT
EO18-33016A
3.5 Ribbon Motor/Ribbon Sensor
3-14
13. Replace the Ribbon Motor and Ribbon Sensor with new ones, and then reassemble in the reverse
order of removal.
NOTES:
1. When re-attaching the Ribbon Motor Drive Unit to the upper frame, be careful not to pinch the lead wires.
For wiring of the lead wires, refer to the following picture.
2. When re-attaching the Ribbon Motor Drive Unit to the upper frame, make sure that the locating pin touches
the left end of the left oval hole. Then, tighten the locating pins with the two screws.
Locating Pin
FLT-3x8 Screw
FLT-3x8 Screw