Filter
Top Products
22
3. TURNING ON THE POWER SWITCH / AUTO JOB START (Cont.)
If you set the desired copying modes and press the START key during warm-up, the copier
automatically starts copying when it becomes READY.
Place the original(s) on the original feed
tray or on the glass.
● After aligning the edges of the originals, set
them
face up on the original feed tray and
align the slides to the edges of the originals.
● See page 24 for the number of the originals
you can set up at a time.
1
Slides
2
Auto Job Start
● Lifting the original cover or the reversing
automatic document feeder, place the original
on the glass
face down and with its bottom
toward you and with its top left aligned against
the original scale on the left side.
● Close the original cover or the reversing
automatic document feeder slowly after the
original size has been detected.
Note: Remove any paper clips or staples from
originals before placing them on the
original feed tray.
Set the desired copy modes.
● The automatic paper selection (APS) mode
and copying of one original are selected as
the default modes, but the original size is not
automatically detected in the auto job start
mode.
When Using the Automatic Document Feeder
When Placing the Original on the Glass