Filter
Top Products
6 GL-1010 Network Fax Operator’s Guide
Installing the Network Fax Kit
Before you can begin using the TOSHIBA optional Network Fax Feature
for the e-STUDIO system, you must install the software using the e-
STUDIO Fax Client CD-ROM provided. Use the InstallShield client software
setup process. This section describes several ways to add the fax driver to
a user’s workstation.
Note: You must have a facsimile board installed in the e-STUDIO
digital copier before you install the fax software. This information is
provided as an overview only. For additional information refer to the
Administrator’s Guide.
Installing the GL-Fax Driver
You can either install the software on each workstation from the supplied
CD-ROM, or upload the software to the controller and use the TopAccess
application to install the software on the workstations.
The recommended installation location is: C:\Program
Files\TOSHIBA\TOSHIBA e-STUDIO GL-Fax and Address Book.
Installing From the CD-ROM
1 Insert the e-STUDIO Fax Client CD-ROM into the CD-ROM drive.
2 If AutoRun is enabled, the setup program begins automatically.
If not, choose Run from the Start menu and then locate the setup.exe
file on the CD.
3 Click OK to launch the setup program.