Filter
Top Products
Problem Procedure
On-screen pointer does not respond to
AccuPoint operation
If a PS/2 or serial mouse is connected, check the
Setup program. The Pointing Device option in the
Others option box should be set to Simultaneous
to use both the AccuPoint and an external mouse.
Make sure the following lines are contained in your
AUTOEXEC.BAT file:
PATH %PATH%;C;\MOUSE
SET LMOUSE=C:\MOUSE
C:\MOUSE\MOUSE
SET TEMP=C:\DOS
These lines are necessary to load the AccuPoint
driver. If they are not there, add them to your
AUTOEXEC.BAT file.
Reload the AccuPoint driver from your backup
diskettes, if you made them as advised earlier in the
manual.
If problems persist, contact your dealer.
PS/2 Mouse
Problem Procedure
On-screen pointer does not respond to
PS/2 mouse operation
Check that the PS/2 mouse cable’s 6-pin connector is
firmly connected to the mouse port on the port
replicator and that the replicator is firmly connected to
the computer.
You may have connected the mouse after turning the
computer on. Turn off the computer, make sure the
mouse is firmly connected and turn the computer back
on.
Confirm that your CONFIG.SYS or
AUTOEXEC.BAT contains a mouse driver.
Is your software configured to recognize the mouse?
Check the software documentation.
If problems persist, contact your dealer.
Serial Mouse
Problem Procedure