Filter
Top Products
Pressing Fn + F3 toggles between Resume mode and boot mode. When you press Fn + F3
in a DOS environment, the Pop-up window below appears at the top left of the display,
showing the current power up mode. Continue holding down Fn and press F3 again to
change the setting.
Battery Save Mode : Full Power
E XXXXXXXXXXXX F
Power-up Mode : Resume
If you press Fn + F3 in a Windows environment, an icon panel is displayed. Continue
holding down Fn and press F3 again to change the setting. The highlighted icon changes
according to the current setting.See Chapter 11, Setup and Password Security for
information on changing the setting using the TSETUP program.
Alarm Volume
Press Fn + F4 to adjust the alarm volume to low, medium, high or off. When you press Fn
+ F4, a beep sounds to let you know the current alarm volume. Continue holding down Fn
and press F4 again to change the setting. The volume at power on depends on the TSETUP
program setting. See Chapter 11, Setup and Password Security..
Display Selection
Pressing Fn + F5 changes the active display device. As indicated in the table below, the
changes depend on the computer’s display type, TSETUP setting and whether you have an
external monitor connected.
TSETUP Active display Change order
Internal/External Internal Int. -> Sim. -> Ext.
External Ext. -> Int. -> Sim.