Filter
Top Products
TE2300
Version
1
Last
S
aved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as
Power and Power-Up Modes
6-13
TOSHIBA TE2300
Removing the battery pack
Installing the battery pack
To install a battery pack, follow the steps below.
The battery pack is a lithium ion battery, which can explode if not properly
replaced, used, handled or disposed of. Dispose of the battery as
required by local ordinances or regulations. Use only batteries
recommended by TOSHIBA as replacements.
1. Be sure the computer’s power is off and all cables are disconnected.
2. Insert the battery pack.
Installing the battery pack
3. Push down the battery pack until it is firmly seated.
Starting the computer by password
If you registered a password as supervisor or user, you must enter it to
start the computer. For more information about how to set a password,
refer to Chapter 7, HW Setup and Passwords.
To start up the computer with the password, follow these steps:
1. Turn on the power as described in Chapter 3, Getting Started and
the following message appears:
BATTERY RELEASE
LATCH
BATTERY PAC
K
BATTERY PAC
K