Filter
Top Products
TE2300
Version
1
Last
S
aved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as
Operating Basics
4-8
TOSHIBA TE2300
Inserting a CD/DVD
When the drawer is fully opened, the edge of the computer will extend
slightly over the CD/DVD tray. Therefore, you will need to turn the
CD/DVD at an angle when you place it in the tray. After seating the
CD/DVD, however, make sure it lies flat, as shown in the figure above.
1. Do not touch the laser lens. Doing so could cause misalignment.
2. Be careful to keep foreign matter from entering the drive. Check the
back edge of the tray to make sure it carries no debris before closing
the drive.
4. Press gently at the center of the CD/DVD until you feel it click into
place. The CD/DVD should lie below the top of the spindle, flush
with the spindle base.
5. Push the center of the drawer to close it. Press gently until it locks
into place.
If the CD/DVD is not seated properly when the drawer is closed, the
CD/DVD might be damaged. Also, the drawer might not open fully when
you press the eject button.