Filter
Top Products
TE2300
Version
1
Last
S
aved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as
Optional Devices
8-5
TOSHIBA TE2300
Inserting the memory module
8. Seat the cover and secure it with one screw.
9. When you turn the computer on, it should automatically recognize
the total memory capacity. Use the HW Setup program to verify that
the added memory is recognized. If it is not recognized, check the
module’s connection.
Removing memory module
To remove the memory module, make sure the computer is in boot mode
then:
1. Turn the computer off and remove all cables connected to the
computer.
1. If you use the computer for a long time, the memory modules will
become hot. In this case, let the memory modules cool to room
temperature before you replace them.
2. Do not try to remove a memory module with the computer turned on
or turned off in Standby and Hibernation mode. You can damage the
computer and the memory module.
2. Turn the computer upside down and remove the battery pack (refer
to Chapter 6, Power and Power-Up Modes.)
3. Remove one screw securing the memory module cover.
4. Lift off the cover.
5. Use a slender object such as a pen to press two latches on either
side of the memory module to the outside. The memory module will
pop up.
6. Grasp the memory module by the sides and pull it out.
Do not touch the connectors on the memory module or on the computer.
Debris on the connectors may cause memory access problems.