Filter
Top Products
TE2300
Version
1
Last
S
aved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as
Operating Basics
4-9
TOSHIBA TE2300
Closing the DVD-ROM drawer
Removing discs
To remove the CD/DVD, follow the steps below and refer to the next
figure.
Do not press the eject button while the computer is accessing the DVD-
ROM drive. Wait for the DVD-In-Use indicator to go out before you open
the drawer. Also, if the CD/DVD is spinning when you open the drawer,
wait for it to stop before you remove it.
1. To pop the drawer partially open, press the eject button. Gently pull
the drawer out until it is fully opened.
1. When the drawer pops open slightly, wait a moment to make sure the
CD/DVD has stopped spinning before pulling the drawer fully open.
2. Turn off the power before you use the eject hole. If the CD/DVD is
spinning when you open the drawer, the CD/DVD could fly off the
spindle and cause injury.
2. The CD/DVD extends slightly over the sides of the drawer so you
can grasp it. Hold the CD/DVD gently and lift it out.