Filter
Top Products
TE2300
Version
1
Last
S
aved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as
Optional Devices
8-4
TOSHIBA TE2300
1. If you use the computer for a long time, the memory modules will
become hot. In this case, let the memory modules cool to room
temperature before you replace them.
2. Do not try to install a memory module with the computer turned on or
turned off in Standby and Hibernation mode. You can damage the
computer and the memory module.
3. If you install a memory module that is not compatible with the
computer, a beep will sound when you turn on the power. If the
module is installed in slot A, there will be a long beep followed by a
short beep. If the module is in slot B, there will be a long beep
followed by two short beeps. In this case shut down the power and
remove the incompatible module.
2. Remove all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack (refer
to Chapter 6, Power and Power-Up Modes.)
4. Remove one screw securing the memory module cover.
5. Lift off the cover.
Use a point size 0 Phillips screwdriver.
Removing the cover
6. Insert the memory module into the connector on the computer.
Press the module carefully and firmly to ensure a solid connection.
7. Push the module down so that it lies flat and is secured by two
latches.
Do not touch the connectors on the memory module or on the computer.
Debris on the connectors may cause memory access problems.