Filter
Top Products
TE2300
Version
1
Last
S
aved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as
Getting Started
3-9
TOSHIBA TE2300
Data save in hibernation mode
When you turn off the power in hibernation mode, the computer takes a
moment to save current memory data to the hard disk. During this time,
the Built-in HDD indicator will light.
After you turn off the computer and memory is saved to the hard disk,
turn off the power to any peripheral devices.
Do not turn the computer or devices back on immediately. Wait a moment
to let all capacitors fully discharge
Standby mode
In standby mode the power remains on, but the CPU and all other
devices are in sleep mode.
1. Before entering Standby mode, be sure to save your data.
2. Do not install or remove a memory module while the computer is in
standby mode. The computer or the module could be damaged.
3. Do not remove the battery pack while the computer is in standby
mode (unless the computer is connected to an AC power source).
Data in memory will be lost.
4. If you carry the computer on board an aircraft or into a hospital, be
sure to shut down the computer in hibernation mode or in shutdown
mode to avoid radio signal interference.
Benefits of standby
The standby feature provides the following benefits:
■ Restores the previous working environment more rapidly than does
hibernation.
■ Saves power by shutting down the system when the computer
receives no input or hardware access for the duration set by the
System Standby feature.
■ You can use the panel power off feature.
Executing standby
You can also enable Standby by pressing Fn + F3. See Chapter 5, The
Keyboard, for details.
You can enter standby mode in one of three ways:
1. Click Start, click Turn Off Computer and click Stand by.
2. Close the display panel. This feature must be enabled. Refer to the
System Power Mode item in Power Saver Utility described in the
Control Panel.