Filter
Top Products
Installation
8
Installation
GB
TOSHIBA TF 471
15.03 TEL 00
3 x
INSTALLATION ?
ID=
_
ID=TOSHIBA
TEL=
_
2 x
standby mode
Start the menu. Press ...
...until this menu item appears.
Confirm.
Press NO ...
Confirm.
Confirm.
Machine prompts user to enter the user
name
Enter the name
Example: TOSHIBA
1 x 8 = T# 3 x 4 = I#
3 x 6 = O# 2 x 2 = B#
4 x 7 = S# 1 x 2 = A
2 x 4 = H#
Confirm with YES.
Machine prompts user to enter the
sender's number (Continue with part 2
without interruption)
Part 1
Part 2
SET TERMINAL ID ?
INITIAL SETTING ?
NO
NO
YES
YES
YES
YES
Enter user name
The following steps include
entering the name, the terminal
identification, the dialling
procedure and the line type. These
settings should be made quickly, as the
maximum permitted pause between data
entry is approx. one minute. Take your
time therefore to read the information
concerning the name, identification,
dialling procedure and line type, and only
start the procedure when you have
finished reading.
If you have not entered all the data within
the permitted time, the details will not be
completely stored. In this case, repeat the
entire procedure again.
The transmission header not only contains
the terminal ID but also the user name.
This can contain up to 20 characters.
Use the digit input keys for entering the
alphanumeric characters.
Each digit features several characters
which can be activated by repeatedly
pressing the corresponding key. If you
have found a character of your choice,
press the ”#” key to go to the next
position. Use the ‘*’ key to go back one
letter and make any corrections. Use the
”0” key to select special characters.
If you have entered one letter too many,
delete it by pressing the NO key.
When the name is complete, press the
YES key. Example: TOSHIBA
SET RECEIVE MODE ?