Filter
Top Products
9.2.4 Port Config
On this page you can configure MLD Snooping function with each single port.
Choose the menu Multicast→MLD Snooping→Port Config to load the following page.
Figure 9-16 Port Config
The following entries are displayed on this screen:
Port Config
Select:
Select the port you want to configure.
Port: Displays the port number.
Filter: Choose to enable or disable filter function in this port.
Filter Mode: Choose the filter action mode. You can accept or
refuse Report message with specific multicast groups
specify by the filter IDs.
Filter IDs: Enter the filter IDs with this port. The filter IDs are
configured in Filer Config. The format is 1,4,12.
Max Groups: Enter the maximum groups which the port can join as
the member port. It ranges from 0 to 256.
LAG: Displays the LAG number.
Note:
1. If the Max Groups value is set less than the current value, some groups may be deleted to
satisfy the restriction.
2. The max number of filter entries on each port is 15.
9.2.5 Static Multicast
On this page you can configure static multicast groups. The multicast groups configured here are
not learned by MLD Snooping and independent of dynamic multicast groups and multicast filters.
The static multicast member ports won’t age out.
Choose the menu Multicast→MLD Snooping→Static Multicast to load the following page.
153