Filter
Top Products
VLAN Creat
e/Delete If selected, the switch will send a VLAN Create/Delete trap when a
VLAN is being created or deleted.
IP Change: If selected, the switch will send an IP Change trap when the IP
address of the switch is changed.
Storm Control: If selected, the switch will send a Storm Control trap when the
broadcast, multicast or UL rate exceeds the limit. You can
configure the limit on QoS→Bandwidth Control →Storm
Control page.
Bandwidth Control: If selected, the switch will send a Bandwidth Control trap when the
traffic rate of a port exceeds the limit. You can configure the limit
on QoS→Bandwidth Control→Rate limit page.
LLDP: If selected, the switch will send an LLDP trap when the status o
f
LLDP changes.
MAC Address Table: If selected, the switch will send a MAC Address Table trap when
the MAC address table has any changes.
Loopback Detection: If selected, the switch will send a Loopback Detection trap when
the status of loopback detection changes.
Spanning Tree: If selected, the switch will send a Spanning Tree trap when the
status of STP on the port changes.
Port Access: If selected, the switch will send a Port Access trap when some
users try to log on to the web management page via ports
that have no authority. You can configure the access control policy
on System→Access Security→Access Control page.
IP-MAC Binding: If selected, the switch will send an IP-MAC Binding trap when it
receives a packet from the host that does not match the rules in
IP-MAC binding table. You can configure the IP-MAC Binding
policy on Network Security→IP-MAC Binding page.
IP Duplicate: If selected, the switch will send an IP Duplicate trap when anothe
r
host uses the switch's IP address.
DHCP Filter: If selected, the switch will send a DHCP Filter trap when it
receives a DHCP packet from an untrusted port.
Port Traps
Port Select: Click the Select button to quick-select the corresponding port
based on the port number you entered.
Select: Select your desired port for configuration. It is multi-optional.
Port:
Displays the port number.
Link Status: Enable/Disable Link Status traps for the desired port.
Note:
To enable the Link Status traps for the desired port, please select the “Link Status” on the SNMP
Traps first, otherwise, it will not take effect.
232