Verizon MBR1515L Network Router User Manual


 
Wi-Fi Settings
36
Verizon 4G LTE Router MBR1515LVW
Note: The authentication is separate from the data encryption. You can
select authentication that requires a shared key but still leaves data
transmissions unencrypted. Security is stronger if you use both the
Shared Key and WEP encryption settings.
5. Select the Encryption Strength setting:
64-bit.
Enter 10 hexadecimal digits (any combination of 0–9, a–f, or A–F).
128-b
it. Enter 26 hexadecimal digits (any combination of 0–9, a–f, or A–F).
6. Enter th
e encryption keys. You can manually or automatically program the four data
encryption keys. These values must be identical on all computers and access points in your
network:
Passphras
e. To use a passphrase to generate the keys, enter a passphrase, and
click Generate. This procedure automatically creates the keys. Wireless stations
must use the passphrase or keys to access the router.
Note: Not all wireless adapters support passphrase key generation.
Key 1Key4. These values are not case-sensitive. You can manually enter the four
data encryption keys. These values must be identical on all computers and access
points in your network. Enter 10 hexadecimal digits (any combination of 0
9, af, or
A
F).
7. Select which of
the four keys is the default.
Data transmissions are alwa
ys encrypted using the default key. The other keys can be
used only to decrypt received data. The four entries are disabled when WPA-PSK or WPA
authentication is selected.
8. Click Apply to save
your settings.
Use Push 'N' Connect (WPS) to Configure Your Wireless
Network
To use Push 'N' Connect, your wireless computers or devices must support Wi-Fi Protected
Setup (WPS). Compatible equipment usually has the WPS symbol on it. WPS can
configure the network name (SSID) and set up WPA/WPA2 wireless security for the router
and the wireless computer or device at the same time.
WPS considerations:
The Push 'N' Connect featu
re is based on the WPS standard. All other Wi-Fi-certified and
WPS-capable products should be compatible with products that implement Push 'N'
Connect.