Filter
Top Products
9 Installation overview
This chapter describes installing software and setting up printing from a
PC-compatible computer running Windows 3.1x, Windows 95, or Windows NT.
Installation overview
To use the Fiery XJ utilities with Windows 3.1x and AppleTalk, you must have
PhoneNET PC or COPSTalk installed to communicate with AppleTalk.
N
OTE
:
You may have to install or configure other programs or files before you can
install the user software.
The general steps for installing the Fiery SI user software are:
• Install the utilities and files using the Installer.
• Move files to the appropriate locations as necessary.
• If you will be using the utilities with Windows 3.1x and AppleTalk, add commands
to the AUTOEXEC.BAT file that enable you to select a Fiery SI from a Chooser-like
window within each Fiery XJ utility.
• If you will be using the utilities with Windows and an IPX/SPX or TCP/IP network,
configure the Chooser list. (This is sometimes done by your system administrator.)
• Install the PostScript Printer Driver you want to use.
• Set up the printer driver to communicate with the Fiery SI.
• If you will be using Adobe Pagemaker, move the printer description file for
applications to the appropriate location.
• If you will be using Photoshop, install the EFICOLOR Separation Tables for your
print device and the monitor setup file.
• If you will be using Fiery XJ Scan, load the monitor settings file.
Insta
lli
ng user
software on a
PC-compatible
computer
This document was created with FrameMaker 4.0.4