Filter
Top Products
23 Configuring the Chooser list
If you want to make changes to this configuration, or if you want to add another
configuration, click Configure.
See “Setting up the Fiery SI as a PostScript printer” on page 26 to continue the
installation process.
TO CONFIGURE THE CHOOSER LIST FOR TCP/IP NETWORKS:
1. Start up any of the utilities (Fiery XJ Downloader, Fiery XJ Spooler, or Fiery XJ Print
Calibrator).
2. Click OK when the following message appears.
3. In the Add New Server dialog box, enter a DNS Name (or IP address) and a Device Code
in the New Device box.
The server name is either the DNS name or the IP address for a Fiery SI server when
you are using TCP/IP with Windows NT. The Server Name is indicated in the Server
Setup section of the Configuration page. The IP address is indicated in the Network
Setup section of the Configuration page.