Filter
Top Products
PRINT FORMAT COMMANDS
6-86 XEROX DOCUPRINT 180 LPS PDL REFERENCE
Points to note — OUTPUT command
Note the following when using the OUTPUT command. These points
to note list parameters followed by the applicable action or system
response.
• DUPLEX=YES
— Any job that runs in simplex mode runs in duplex mode
except transparencies.
— A recoverable dispatching or imaging error on an even-
numbered page results in one additional hole in the paper
path and up to seven aborted pages to the sample tray. A
recoverable dispatching or imaging error on an odd-
numbered page results in one additional hole in the paper
path with no aborted pages to the sample page.
• COLLATE
Once you have specified multiple copies, the value of the
COLLATE parameter cannot be changed again within the
report.
• NT01, FACEUP, DUPLEX, COLLATE
The NT01, FACEUP, DUPLEX, and COLLATE parameters
follow a specific hierarchy by which one command parameter
forces changes in certain other command specifications when a
YES option is selected. This hierarchy of forced conditions is
shown in table 6-71. The first column gives the condition that
will force the parameters shown in the columns to the right.
Example: FACEUP=YES, COLLATE=NO;
Example: NTO1=YES, FACEUP=NO;
• NTO1 and 1TON system defaults
— During system generation, you may select either 1TON or
NTO1 as the system default in the DEFAULT ORDER =
{1-N | N-1} window.
— When the system default is 1TON, NTO1 is processed only
if it is invoked in the JDE or JDL. The system ignores NTO1
in DJDE-selected JDEs or JDLs.
— When the system default is NTO1, the system assumes
each report is NTO1 until the first data page, even if 1TON
is specified in the JDE or JDL. This arrangement allows
you to use DJDE-selected JDEs and JDLs that invoke
NTO1 after a series of banner pages.
— The following examples illustrate these conditions:
Table 6-72. OUTPUT command parameter hierarchy of forced
conditions from highest to lowest priority
Parameter
specification
Results in
NTO1=
Results in
FACEUP=
Results in
COLLATE=
Results in
DUPLEX=
NTO1=YES — — YES
specified
option
FACEUP=YES — — —
specified
option