Filter
Top Products
PRINT FORMAT COMMANDS
6-88 XEROX DOCUPRINT 180 LPS PDL REFERENCE
• DUPLEX=NO, ACCT USER=TRAY, BFORM ignored, RPAGE
SIDE=NUBACK, forced to NUFRONT
If transparency (TRANS) is specified, the input task forces
these parameters. Any operator key-ins, however, override the
JSL specifications.
• CYCLEFORMS, FORMS
Both may be used within a report; however, only the last
parameter specified is in effect at any given time. If a multicopy
report specifies CYCLEFORMS, a FORMS DJDE encountered
midreport overrides the CYCLEFORMS parameter from that
point in every copy.
• RAUX command, FEED parameter of OUTPUT command
If they specify two different cluster names, RAUX has higher
priority.
• SYSPAGE parameter of STOCKSET command
System pages are checked for ordered stocks through the
SYSPAGE parameter. If there is no cluster name active for the
current page, the input task checks to see if there was an
operator FEED cluster-name specified. If so, the input task
tests on the operator’s specified cluster-name.
• Ordered stock (OSTK)
All applications that are printed on the tab have pages
formatted for tab printing. If there is a PDE switch in the job
stream that causes the BEGIN value to be shifted off the page,
(BEGIN=(.18, 8.6)), the cluster criteria must already be met
before processing the new BEGIN. This allows the input task to
bypass BEGIN value checking for tab stocks.
PDL ensures the minimum value for MOD is 1 and the
maximum is 254 (decimal). It also ensures the value of POS is
greater than or equal to 1 and less than or equal to MOD.
• Printing on a tab
— The DocuPrint 180 prints on tabs in both simplex and
duplex modes.
When printing on 9-inch stock or 8.5-inch stock with 1/2 inch
tabs, the full imaging area of 9-inch is enabled. It is limited,
however, by the amount of image shift enabled.
— When running a tab stock job, you must not include the
width of the tab when specifying the PAPERSIZE
command. However, the width of the tab must be factored
in when reporting the paper size to the system with the
SET TRAY SIZE command on the “Tray size” screen or on
the printer monitor.
— A command DJDE FEED=Cluster name/cluster reference
is required to switch to tab stock or whatever it would need
to switch the current cluster to a tab stock cluster. This may
include RAUX, RFEED, COVER=FRONT, operator keyin,
etc.
— INPUT processes tabs by keying off the current cluster
name/reference at the time that the page is formatted for
OUTPUT. For example, if the page satisfies the RAUX
criteria and AUX is specified as the cluster name in the
ordered stock statement, INPUT recognizes this as a tab