Filter
Top Products
PRINT FORMAT COMMANDS
XEROX DOCUPRINT 180 LPS PDL REFERENCE 6-101
The following sections describe the syntax of the command
parameters and explanations of the parameter options.
BEGIN
This parameter specifies the location of the starting print line of a
logical page for graphics. The vpos parameter specifies the vertical
position of the first character of the first print line on the logical page.
It may be specified in inches (IN) or centimeters (CM). The default is
inches.
Syntax
ac
:PDE BEGIN =
option(s)
Options Table 6-75 lists the parameter option(s) and definition(s).
Considerations In specifying the location of the beginning of a print line on the logical
page, measurement is performed by viewing the page in the mode
(landscape or portrait) in which it is to be printed. There may be more
than one logical page per physical page; these are defined by the use
of multiple BEGIN parameters. If no BEGIN parameter is specified,
then the default is FMT1.
Table 6-76. BEGIN parameter option(s) and definition(s)
Option(s) Definition(s)
(
vpos
,
hpos
) This option has the following components:
•
vpos
Specifies a decimal number with up to three
digits to the right of the decimal point, such as
0.563 IN and 2.35 CM, are all legal
specifications).
The default is .18 IN.
•
hpos
Specifies the horizontal position of the first
character of the first print line on the logical
page (in IN or CM as for vpos). All specifications
are rounded to the nearest dot (1/300 of an
inch) for positioning of the logical page.
The default is .66.