Filter
Top Products
PRINT FORMAT COMMANDS
XEROX DOCUPRINT 180 LPS PDL REFERENCE 6-95
You may also specify pitch mode boundaries in centimeters
(CM), DOTS, and XDOTS. The minimum and maximum scan
values with these units of measurement and the pitch mode
ppm print speeds are shown in table 6-72.
• Purging stock
The DocuPrint 180 LPS can purge tab sheets whenever the tab
cycle is not in sync with the formatted data. This may be caused
by paper jams or running multiple jobs in succession. For
example, if a typical application had the following scenario:
Two tab stock jobs to run in succession. Both jobs require tray
1.
Tray two contains the tab stock which has MOD=5.
Job 1 starts with Tab 1 (located in the upper right corner of a
portrait page) and Job 2 must start with Tab 5 (located in the
lowest right corner of the portrait page.)
The number of tabs Job1 will use is 2.
In order to run the job in succession, you must code the JSL
with MOD=5 and POS=1 for Job 1 and MOD=5 and POS=5 for
Job2. The DocuPrint 180 will keep track of the last tab position
in tray 2 at the end of Job 1. Upon starting Job 2, the DocuPrint
180 LPS will purge Tab 3 and Tab 4 because Job 2 starts with
POS=5 and Job 1 used Tab 1 and Tab 2.
You can improve performance by ordering application-
dependent tab stock. By using ordered tab stock which
supports only those number of tabs required for a specific job,
you will eliminate the system from purging unused tabs.